Run the commands below to create a tunnel file called wg0.conf This can be done using the ip or wg command.įor easier management, you can create a tunnel file and add its configurations to it. These key files will be generated and stored in the /etc/wireguard directory.Īfter generating the key pair above, your next task will be to create a tunnel device that will be used to route the VPN traffic. Run the commands below to generate the public | and private key pair. These keys are vital to the operation of a VPN for secure communications. Now that you’ve installed WireGuard, follow the steps below to configure it.įirst, go and create private and public keys. WireGuard is now installed and ready to be configured. This will install the repository file and fresh the system’s package sources.Īfter installing WireGuard, you should see a similar message as shown below: Next, add the PPA repository and install WireGuard. To add WireGuard PPA and install from there, run the commands below to get some update Ubuntu and install some basic packages. Use this repository to install WireGuard so that when newer versions are available, your system can install them.

WireGuard has a PPA repository that is well-maintained.

To get started with installing and configuring WireGuard, follow the steps below: Install WireGuard Server # Ubuntu is an open-source Linux operating system that runs on desktops, laptops, servers, and other devices. It’s a great Linux operating system for beginners.

If you’re a student or a new user, you will find out that the easiest place to start learning Linux is on Ubuntu Linux OS. WireGuard uses a peer-to-peer VPN module, and depending on how you configure it, it can serve as a traditional VPN server or client. It is easy to install and configure, and if you’re looking for great open-source VPN software to secure your communication, WireGuard is a great place to start. WireGuard is a novel VPN (Virtual Private Network) that runs inside the Linux kernel.

Install softether vpn server linux